Bk gamma

Hello , what config should i use for bk wave from gamma?
I have:goliath,12bo2,26lf3,1lf4,5iris,heart,14pp.

 

ЦΠÐΣRCØVΣR™,
There are many ways you can set your ship up depending on how you play. I will leave this open and see if anyone can post some "tried and true" configurations that may assist you.

Best regards,
.-Raijin-.

 

you do not need that much speed in this wave.
I would suggest one heavy slow with all lasers on iris and ship and all shields on ship
second config a fast all shields in iris and full speed so if u get some lag u change config and run from them without dying.

sorry if my advice doenst work but I do all my gates with x3 double booster and seprom plus im already UFE so i have no troubles doing it and they die really fast.

be careful with lag one shot you have to run because you might see they didnt damage you that much but when u actually start repairing then your shields and ur hp will go down. has happened to me before and i was surprised.

good luck !

 

Tbh, i'd leave that gate for now, and focus on getting f.e first, because with those stats, it'd take you quite some time...

However, if you still want to persue with the gate, then i'd say having 1 config with a bit of speed, and 1 tank config.
speed config, have 10 speed gens, 5 shield on ship, with 15 lasers on ship. And on drones, have 2-4 shield on drones, and fill the rest with lasers.
Battle configs , have full lasers and shield on ship[, on drones have 1/2 shield gens on drones, and fill the rest with lasers.

Advice, circle alot and be wary of lag.

 

i use all lasers drones and ship but not to slow conf. put from 8 to 12 shields rest speed. and secund one full shields and full speed.
use seprom if you have or promerium for lasers, and if you have x2 or x3 that hellp a lot. i did my first gamma before all this new stuf, have had only 4 iris and 23 lf-3.
was doing that kristallon wave more than 3 hours and have spend lots of x1 ammo hehe.

just to add, dont let them to go in corner stay close to midle of map and finish them there to save some time, and if you lag and get killd those that you have kill will not get back.

i hope this make sense english is not my language.

 

Hi Undercover
I would second Warrior's advice and leave this gate for the moment, concentrate perhaps on alpha and epsilon until you are FE. Gamma isn't really one to do in a sub elite ship.
Most difficult waves on gamma tend to be lks and lil sibs, just because theres so many of em.
reduce risk of lag and freeze by relogging between waves, minimising your graphics settings, and keeping the bulk of the swarm just offscreen by dragging your target.

If you still want to try this bk wave ( and if you actually are on the bk wave you have completed the worst of the gate imo ) i would put sep on shields, prom on speed, full shields on drones and ship for first config, full shields on drones and full speed on ship on second config, so you can run and rep.

as they are x3 normal dmg, i would have loads of sab
as they are x3 shds and hp, i would be using x3 or x4, with 3030's, otherwise you will be there forever.

These are not the configs I use, i would never even attempt that number of x3 npcs in a ship of your spec, it would be suicide lol.

I use lvl3 kami loads on this wave, i have 7 fully upgraded lf4s, full upgrades on drones and hellstorm, apis, etc.

again my advice, like warrior says - leave it for now
regards

 

Thank you guys , i done bk wave but now i have some problems with protegits, i will leave this gate for moment Thanks again.

 

Hello ЦΠÐΣRCØVΣR™

Thank you all for assisting with this thread.

Do you (the original poster) have any further questions or can we close?

 

Just wanted to ask - can we do Epsilon before Gamma? I'm asking because I never get any gate parts for anything other than Alpha, Beta or Gamma just now. Don't we have to complete those three before getting parts for other gates?

Edited to add - I've already completed Alpha twice and Gamma once - still only get parts for the first three gates though.

 

yes! just use spins on gate you want to do. click on that gate and spin...

 

Ok, thanks. I'll give it a try.

 

Due to lack of response by the OP it would appear that this matter has been resolved and therefore the thread will be closed.

Best regards,
.-Raijin-.